Ruger American Rimfire Target .17 HMR
Model: 8393
Ruger American Rimfire Target .17 HMR
Model: 8393
Full Specifications
Threaded 1/2x28 barrel: compare rimfire suppressor prices.
About This Firearm
The Ruger American Rimfire Target is a synthetic-stocked bolt-action .17 HMR built to be shot from a rest. It has an MSRP of $509.00. Its heavy 16.1-inch barrel is threaded 1/2x28 under a protector, and a bedding block locates the receiver and free-floats the barrel, which steadies a 5.3 lb rimfire off a bag.
A one-piece Picatinny base is installed at the factory and there are no sights anywhere, so an optic and rings are part of the purchase. The stock carries a high comb module meant for a scope, and swapping modules takes nothing more than pulling the rear sling swivel stud. The trigger adjusts between 3 and 5 lbs, and a receiver-mounted release drops the bolt out without a trigger pull. Length of pull is a fixed 13.75 inches on this trim, so a smaller shooter needs one of Ruger's compact modules. The flush rotary magazine holds nine, and Ruger's longer magnum rimfire magazine fits as well.
If you're cross-shopping, the CZ-USA 457 Varmint in the same chambering is 1.97 lbs heavier on a 20-inch barrel, with a walnut stock, an 11 mm dovetail in place of a rail, no muzzle thread, and a trigger that goes down to 1.8 lbs. The Ruger American Rimfire in .22 Magnum has an MSRP of $469.00, shares this action, and comes with a fiber optic front sight and an adjustable rear on a 22-inch sporter barrel at 6.0 lbs. The short heavy barrel balances well, and it gives up some of the velocity .17 HMR is loaded for.
Best For
Strengths & Limitations
- A 60-degree bolt throw leaves room for a large objective bell over the receiver.
- The trigger is Ruger's Marksman Adjustable, set with a screw, so it does not need replacing.
- The supplied magazine sits flush with the stock, so a bipod or a front bag never fouls it, and the longer magnum magazine is an option and not a requirement.
- Length of pull is fixed on this trim, and the sighted rifles in the line come with two comb modules where the Target gets one.
- Magazines for it are cut for the rimfire magnums, so they are not shared with the .22 LR rifles in the same line.
- Compact comb modules and spare magazines are both separate purchases from Ruger, so the closest fit costs more than the rifle arrives with.
Ballistics Calculator
Calculate trajectory, drop, and energy for .17 HMR ammunition.
.17 HMR Ballistics →Frequently Asked Questions
How does the Target trim differ from the sighted American Rimfire rifles?
Barrel, sights and base. Target means a heavy threaded barrel, a factory Picatinny base and no irons. The sighted rifles use a sporter barrel, a fiber optic front sight and a rimfire dovetail machined into the receiver, which is drilled and tapped for Weaver bases as well. The action, trigger and tang safety are shared.
Can it be suppressed?
Yes. The 1/2x28 pitch at the muzzle is the common rimfire thread, so brakes, muzzle devices and suppressor mounts cut for rimfire thread straight on under the factory protector.
What is the bedding block?
Ruger calls it Power Bedding. It is an integral block that locates the receiver positively in the stock and holds the barrel clear of the forend along its length.